High-efficiency cooling systems built specifically for Auckland’s muggy summer climate. We pull latent moisture out of your indoor air quickly, keep running costs low, and deliver whisper-quiet operation across homes and commercial sites.
Uses advanced inverter technology and high COP (Coefficient of Performance) ratings to deliver maximum cooling output with minimal draw on your power bill.
Sealed wall penetrations, mould spore reduction, and multi-stage air filtration deliver safe, clean indoor air with zero exposed heating elements.
Engineered for Auckland’s 80%+ relative humidity. Strips excess moisture out of the air to eliminate muggy indoor conditions, dampness, and mould growth.
Switches smoothly to heating mode when winter arrives, delivering fast, cost-effective warmth even when outdoor temperatures drop near freezing.
A single split system is the most practical option for cooling main living areas, master bedrooms, or home offices. Built for low power draw, quiet running, and fast heat removal when a summer heatwave hits.
Keep your outdoor deck and patio clear. A multi-split system lets you run up to five indoor fan coils off a single high-capacity outdoor inverter condensing unit.
The gold standard for whole-home climate control. The main indoor unit sits hidden inside your roof cavity, distributing conditioned, filtered air through insulated acoustic ducting to discreet ceiling grilles.
No shortcuts. Every system we fit meets NZ Building Code requirements and strict refrigeration trade standards.
We calculate precise cooling loads based on room volume, insulation R-values, glazing surface area, and solar exposure while verifying your main switchboard's spare breaker capacity.
Our tradies protect your floors with drop sheets, secure fan coils properly, fit neat trunking, and seal all exterior penetrations to NZ Building Code Clause E2/AS1 weather-tightness rules.
We run a dry nitrogen pressure test, followed by a deep vacuum evacuation below 500 microns to strip every drop of moisture from the copper pipework before releasing refrigerant and walking you through system operation.
Our registered practitioners evaluate structural access, map line-set runs, verify switchboard capacity, and provide clear, itemised trade quotes.
Provide your details below and a trade engineer will review your layout.
